Category:Contexts and engravers
Contexts and engravers are explained in the Learning Manual.
Pages in category "Contexts and engravers"
The following 89 pages are in this category, out of 89 total.
A
- Adding ambitus per voice
- Adding an extra staff
- Adding an extra staff (2)
- Adding an extra staff at a line break
- Adding bar lines to ChordNames context
- Adding volta brackets to additional staves
- Alternate lyrics context for song sheets
- Alternate lyrics context for song sheets (alternate)
- Alternate \textSpanner engraver
- Ambitus after key signature
- Analysis brackets with labels
- Automatically changing the stem direction of the middle note based on the melody
- Automatically display key names above key signatures
C
- Centered measure numbers (obsolete in 2.23)
- Centering markup on note heads automatically
- Centering multi-measure rests
- Changing MIDI output to one channel per voice
- Changing time signatures inside a polymetric section using \scaleDurations
- ChordNames in a ChordMarkup-context
- Coloring successive intervals
- Conducting signs, measure grouping signs
- Creating arpeggios across notes in different voices
- Creating blank staves
- Creating cross-staff arpeggios in other contexts
- Creating custom key signatures
- Cross-staff stems
- Customizing chord symbols – global
D
G
M
P
- Percent repeat counters for piano music
- Permitting line breaks within beamed tuplets
- Piano “half sustain pedal” indications
- Placing rehearsal marks other than above the top staff
- Polymetric section: printing full-measure rests
- Polymetric section: synchronizing different groups of staves
- Polyrhythmic staves
- Positioning two opposite \fermata signs over the last bar line
- Print chord names with same root and different bass as slash and bass note
- Printing figured bass extender lines without a starting figure
- Printing figured bass figures above rests in a Staff context
- Printing marks on every staff
- Printing music with different time signatures